Your search returned 77 items.
The attached example demonstrates the use of stochastic switching in PowerFactory, including a description on how to use it. The study case contains a DPL script "Stochastic Switching" which simulates…
In the attached PowerFactory project, a current source is configured to inject fundamental frequency and harmonic currents into the system. The simple network model contains a current source which is…
Tags
A Matlab model can be easily linked with PowerFactory by means of the FMI Standard. Please refer to the PowerFactory User Manual, Chapter Models for Dynamic Simulations, Section Interfaces for Dynamic…
You will need to perform an EMT-type simulation for this purpose. To replicate the fault on the cable insulation, the cable must be explictly divided in two sections at the point where the faulty…
If you want to simulate the synchronisation of two different systems, you can model and simulate both systems as separate networks. After some seconds you can then connect them with a circuit breaker…
To model the initial conditions (voltage) of a capacitor bank, you should use a "parameter event" (SetParam) on the variables "uC_a", "uC_b", "uC_c" (signals of the "ElmShnt"). Please find attached an…
Attached you find an example with 3 unsymmetrical voltage sources. It is required to use 3 symmetrical voltage sources and to connect them to the load busbar using 3 single-conductor cables (phase A…
Tags
A static load model is always equivalent to a constant impedance model. For modelling any other characteristic, you have to define a general load type (TypLod) and, on the Simulation RMS page, switch…
In the attached example project the battery is connected to the grid using a PWM converter. The grid contains a synchronous machine which supplies a load. After the initialization the synchronous…
There are several ways of modelling an SVC system: Using the SVS Interface in PowerFactory: A number of standard controls for SVS are available in the global library. There, you can also find…
Tags