Your search returned 189 items.
The damping of transient phenomena during a transient simulation is due to 2 causes: Physical damping and numerical damping. - The physical damping is due to the behaviour of the modeled electrical…
Tags
The CIM profile CGMES is a quite complex profile, where not all is available within each software. Therefore it could happen that some data within the CGMES models are slightly wrong or incomplete.…
Tags
In order to create a Bode diagram you will need to use the Model Frequency Response command (ComFreqresp). This command is described within the User manual, section "Frequency Response Analysis",…
In dynamic simulations, a breaker/switch can be opened via the Switch Event (EvtSwitch). The Switch Event can be parameterised in order to configure the opening process. Furthermore, the breaker…
In dynamic simulations, a breaker/switch can be closed via the Switch Event (EvtSwitch). The Switch Event can be parameterised in order to configure the closing process. Furthermore, the breaker…
The Cable Ampacity calculation can be used in PowerFactory to precisely calculate the rating of a cable. It can only be executed when the geometrical data of a cable is defined by the use of a cable…
The two cable analysis tools each have distinctive applications that they can be used for: Cable Sizing: Planning a network from scratch Create new or select existing cable types Determination of the…
Refer to the attached project. The options shown are: Direct start with star-delta switching: Parameter i_star = 1 (Star), i_star = 0 (Delta) Additional rotor resistance: signal rradd (can also be…
If you want to simulate the synchronisation of two different systems, you can model and simulate both systems as separate networks. After some seconds you can then connect them with a circuit breaker…