Your search returned 31 items.
Yes, it is possible to exchange variables between two composite models in the same way as it is done between two common models. It is only necessary to set up a frame in which the two frames are…
The idea of the initialisation is to preset the internal model signals by the results of an initial load flow.The key point is to first check for each DSL-model, which inputs/outputs are known and…
- EMT SimulationThe model used permits the direct modification of the ignition angle (alpha).- RMS SimulationThis model is slightly different, as the application of a soft starter does not allow a…
If you want to simulate the synchronisation of two different systems, you can model and simulate both systems as separate networks. After some seconds you can then connect them with a circuit breaker…
For RMS simulations the load type has to be set to 100% dynamic load, this means constant impedance Z. Additionally in the RMS dialogue of the load type the voltage dependency of P and Q can be set.…
Refer to the attached project. The options shown are: Direct start with star-delta switching: Parameter i_star = 1 (Star), i_star = 0 (Delta) Additional rotor resistance: signal rradd (can…
A simple moving average discrete time filter is provided for your reference. It can be used for both RMS and EMT type simulations. The register model (ElmReg) could be used to calculate a moving…
The A-stable integration algorithm is described in the PowerFactory User Manual, Chapter "Stability and EMT Simulations", Section "Algorithm control".…
A measurement file object (ElmFile) is used for this purpose. Attached you can find a small example which displays the first 3 channels of a ComTrade file. A measurement file object (ElmFile) is…
Refer to the attached example. It describes an induction generator with the necessary dynamic models. The reactive power is balanced using a switched capacitor. The dynamic models are a shaft model…
Tags