Your search returned 445 items.
For RMS simulations the load type has to be set to 100% dynamic load, this means constant impedance Z. Additionally in the RMS dialogue of the load type the voltage dependency of P and Q can be set.…
It is recommended to have only more than one slack generators in the following cases: Lump representation of the external network: when you have two connections from your network and…
The attached example includes the VSD_200kW template representing a variable speed drive driving a 200 kW motor.  The example provides multiple study cases: SC01 - Motor started (no re-acc) - RMS…
In the rectifier model, you can specify a rectifier as either a rectifier with a commutating reactance or just as a rectifier without a commutating reactance. The Technical Reference…
The surge arrester model consists of a non-linear resistance that can be entered point by point.  The surge arrester is connected to Bus B and the element input characteristic is governed by…
Only the parameters inside the frame (Sub-)Conductor are defined for sub-conductor. All other parameters (e.g. rated current) are specified per bundle. The tower type only specifies…
Tags
The attached example shows how to model an ideal 3-phase transformer, representing the influence of the delta winding in addition to three single phase transformers with different short…
Firstly, it is considered a transformer that has a tap changer on the HV side, with a voltage source of 100 V on the HV. If the tap is on the position where the primary turns are np=50 then the…
This is possible by using a trick. Enter as the phase of the additional value an angle of phiu: phiu=180 degrees.…
In the attached example project the battery is connected to the grid using a PWM converter. The grid contains a synchronous machine which supplies a load. After the initialization the synchronous…