Your search returned 409 items.
It is not possible to change the voltage set point of an external grid during a simulation. The work around is to replace the external grid by an AC voltage source (ElmVac) and then use one of the…
The AC voltage source can be controlled in RMS simulation by applying different input values to signal sets (u0,f0) or (U0,F0Hz). The first set controls the per unit quantities, the second absolute…
Assuming a harmonic voltage measurement is present and needs to be converted into current injections, the following steps need to be taken:1. Convert the measurement data from phase voltage…
Please refer to attached project. The project exemplifies the following systems:   - Single phase diode rectifier, full bridge with capacitive load - Single phase diode rectifier, full bridge…
There are many advantages of using built-in PowerFactory models for power electronics, ranging from the simplicity in configuration to the full support of all relevant calculation functions.…
This example can help you understand the following: - the purpose of the commutation reactance while applying it to the HVDC-LCC element (ElmHvdclcc); nevertheless, the same procedure applies to line…
  Refer to attached example project. It contains a basic example on how such a procedure could be implemented. The project is built based on the Resonance Studies Application Example. It contains…
In dynamic simulations, a breaker/switch can be opened via the Switch Event (EvtSwitch). The Switch Event can be parameterised in order to configure the opening process. Furthermore, the breaker…