Your search returned 75 items.
Studies involving WAMS (Wide Area Measurement System) and PMU (Phase Measurement Units) are typically executed with RMS simulation as it is the faster than EMT simulation when dealing with larger…
The simulation results are not always on a fixed time base due to interruptions happening during the simulation. The attached project contains a script which uses first the Comtrade export to get a…
The attached example provides a simple network where one single phase static generator (converter) is directly being controlled via DSL to set the output active and reactive power (constant power…
The attached example provides a simple network where one three phase static generator (converter) is directly being controlled via DSL to set the output active and reactive power (constant power…
Several EMT studies (transformer energisation, load rejection, ferro-resonance etc.) require a detailed model of the non-linear behaviour of the transformer iron core which is defined by its…
A PowerFactory 2018 (and onwards) example along with two papers is provided for your reference. An example of a PowerFactory implementation of a fast voltage controlled based method for converter…
The static generator allows to control the negative sequence currents via the input signals i2d_ref and i2q_ref. Internally is the cosref, sinref signal used for the transformation (which is typically…
Refer to the attached project which is based on the Transmission example and is focusing on study case "03 Transient Stability". The case reproduces a 100 ms fault event and the post fault recovery…
Refer to attached project file. The project contains two IEEE 39 bus test systems connected via two long power lines between bus 29 - bus 09 and bus 23 - bus 10.  The following study cases are…
In order to create a Bode diagram you will need to use the Model Frequency Response command (ComFreqresp). This command is described within the User manual, section "Frequency Response Analysis",…