Your search returned 66 items.
The options available are the following: Voltage  Measurement Device and Current Measurement Device (StaVmea and StaImea). These elements implement the measurement of time-dependent data of a…
The best option is to model the TCR using a SVC model and setting the number of capacitors to zero, as shown in attached example. In order to analyze the harmonic distortion of the current…
Yes, it is possible to exchange variables between two composite models in the same way as it is done between two common models. It is only necessary to set up a frame in which the two frames are…
The idea of the initialisation is to preset the internal model signals by the results of an initial load flow.The key point is to first check for each DSL-model, which inputs/outputs are known and…
The damping of transient phenomena during a transient simulation is due to 2 causes: Physical damping or numerical damping. - The physical damping is due to the behaviour of the modeled electrical…
Tags
In the attached example a test grid is used to shown an example configuration for a FFT (Fast Fourier Transformation) element. The example includes two Composite Models one using a three phase FFT…
You will need to perform an EMT-type simulation for this purpose. To replicate the fault on the cable insulation, the cable must be explictly divided in two sections at the point where the faulty…
- EMT SimulationThe model used permits the direct modification of the ignition angle (alpha).- RMS SimulationThis model is slightly different, as the application of a soft starter does not allow a…
If you want to simulate the synchronisation of two different systems, you can model and simulate both systems as separate networks. After some seconds you can then connect them with a circuit breaker…
For RMS simulations the load type has to be set to 100% dynamic load, this means constant impedance Z. Additionally in the RMS dialogue of the load type the voltage dependency of P and Q can be set.…