Your search returned 14 items.
Yes, it is possible to exchange variables between two composite models in the same way as it is done between two common models. It is only necessary to set up a frame in which the two frames are…
The idea of the initialisation is to preset the internal model signals by the results of an initial load flow.The key point is to first check for each DSL-model, which inputs/outputs are known and…
For RMS simulations the load type has to be set to 100% dynamic load, this means constant impedance Z. Additionally in the RMS dialogue of the load type the voltage dependency of P and Q can be set.…
A simple moving average discrete time filter is provided for your reference. It can be used for both RMS and EMT type simulations. The register model (ElmReg) could be used to calculate a moving…
Refer to the attached example. It describes an induction generator with the necessary dynamic models. The reactive power is balanced using a switched capacitor. The dynamic models are a shaft model…
For PowerFactory 2021 and earlier please refer to this example and attached files. For PowerFactory 2022 and onwards, this example is not supported anymore. Instead, a much easier alternative is…
PowerFactory includes built-in devices to measure current (StaImea), voltage (StaVmea) and power (StaPqmea). Since PowerFactory version 2022, these devices calculate the instantaneous values, true RMS…
It is possible to represent photovoltaic (PV) systems in PowerFactory for the purpose of power system analysis. It is important to decide from the very beginning on the type of analyses being carried…
A PowerFactory 2018 (and onwards) example along with two papers is provided for your reference. An example of a PowerFactory implementation of a fast voltage controlled based method for converter…
In order to create a Bode diagram you will need to use the Model Frequency Response command (ComFreqresp). This command is described within the User manual, section "Frequency Response Analysis",…