Your search returned 38 items.
If the option "Current source model: Use negative sequence angle for negative sequence current source" is enabled, the negative sequence angle is either calculated internally or can be defined via the…
In order to create a Bode diagram you will need to use the Model Frequency Response command (ComFreqresp). This command is described within the User manual, section "Frequency Response Analysis",…
In general, instantaneous values are calculated in EMT simulations. Such instantaneous values must be processed in order to calculate RMS signals, such as voltages and current. The following are two…
PowerFactory offers with the simulation scan also the possibility to observe the solver. This allows the user to define a parameter simulation scan which can stop the simulation in case of high number…
A modular implementation of the WECC dynamic composite load model (CMPLDW) is included as a Template in PowerFactory versions 2020, 2021, 2022 and 2023. The latest version of this Template is now…
Refer to attached example. It contains an IBR model and a three-phase fault is simulated in both RMS and EMT. The IBR model can operate in both RMS and EMT, whereas in EMT it can be changed from an…
Default parameters for a DSL model can be created by defining a corresponding ElmDsl (DSL model) inside the BlkDef (DSL model type) and adding the corresponding default parameters. If these are…
The attached PDF gives an overview of the different modelling approaches available in PowerFactory. Please contact support before you start modelling if you are unsure about the best option for your…